What type of connector does the sensor use?
The standard sensor uses a Bulgin 4000 series connector.
Related Articles
What software do I need to configure the sensor?
You need the Tan Delta CADS application to configure a sensor. This is designed for windows PCs and can be downloaded HERE All sensors must be configured prior to use for both the communication type to be used and also for the oil the sensor is to be ...Which communication protocols does the sensor support?
The sensor is capable of outputting oil condition and oil temperature in both an analog signal and a digital signal as follows: Analog: 4-20mA Installing on systems with a current sensing input Installing on systems with a voltage sensing input ...Do I need to configure the sensor?
Yes, the sensor is configured using a PC, configuration cable (Cable J) and the Tan Delta CADS application prior to installation. Help and support for the installation and use of the CADS application can be found HERE Prior to installation the sensor ...How do you clean the sensor?
Once installed in application, there is no requirement to clean the sensor. When using the sensor with the MOT kit or if you are using the sensor in bench testing, the sensor should be cleaned between oil types. We recommend using a low residue ...Does the sensor need annual calibration?
No, there is no need to calibrate the sensor annually. If the oil the sensor is to be used in is changed to a different oil, then the sensor needs to be reconfigured for this oil using the CADS application. If the oil type remains the same, but the ...